Bölüm "Havacılık ve Uzay Bilimleri Fakültesi -- Uçak Bakım ve Onarım Bölümü" Mühendislik ve Doğa Bilimleri Fakültesi için listeleme
Toplam kayıt 6, listelenen: 1-6
-
Conceptual design and optimal sizing of a small unmanned aerial vehicle with fuel cell and battery-powered hybrid propulsion system by meta-heuristic algorithms based on energy consumption
(Taylor and Francis, 2023)In this paper, a new conceptual design methodology for a hybrid propulsion system consisting of the battery and hydrogen fuel cells is presented based on the minimum energy consumption of the UAV. In this context, an ... -
The effects of interface and matrix reinforcements on fracture toughness of E-Glass/epoxy laminate
(Institute of Physics Publishing, 2020)In this study, the effects of low amount (0.1 wt%) multi-walled carbon nanotube (MWCNTs) distributed homogenously in epoxy via cationic surfactant (cetyl pyridiniumchloride-CPC), polyacrylonitrile nanofiber (in the range ... -
Fatigue analysis of bolted flange joints of a rotary dryer
(Elsevier, 2016)This paper describes the fatigue failure of a rotary dryer in a chemical plant. The process conditions required the dryer to be rotated continuously at a speed of about two and half revolutions per minute. The shell structure ... -
Improving Autonomous Performance of a Passive Morphing Fixed Wing UAV
(Kauno Technologijos Universitetas, 2020)In this article, simultaneous longitudinal and lateral flight control systems design for both passive and active morphing unmanned aerial vehicles (UAVs) is first time applied for autonomous flight performance maximization. ... -
Katı Yakıtlı Roket ALP-01 Tasarımı, Modellemesi ve Simülasyonu
(Avrupa Bilim ve Teknoloji Dergisi, 2019)Bu çalışmada katı yakıtlı alçak irtifa roketi ALP-01’in CAD tasarımı yapılmıştır. 1500 metre irtifa için roket boyutları; seçilen motor için optimize edilmiştir. Burun konisi geometrisi olarak Parabolik tip tercih edilmiş ... -
MWCNTs doped GFRPs drilling: crosscheck among holes obtained by alternative manufacturing methods
(Springer, 2021)In this study, the holes of glass fiber reinforced polymer (GFRP) and multi-walled carbon nanotubes (MWCNTs) doped GFRP composite materials were drilled using abrasive water jet (AWJ), CO2 laser cutting, orbital drilling, ...