Ara
Toplam kayıt 10, listelenen: 1-10
Investigation of microstructure and mechanical properties of friction stir welded dissimilar St37/St52 joints
(Institute of Physics Publishing, 2019)
Although friction stir welding (FSW) has widely been applied to aluminum alloys in several industries over the past three decades, it is not yet used in industry for joining of steels. The aim of this study is to characterize ...
Properties and Tribologic Behavior of Titanium Carbide Coatings on AISI D2 Steel Deposited by Thermoreactive Diffusion
(Springer, 2018)
In the present study, the metallographic, mechanical and tribologic behaviors of AISI D2 steel specimens coated with TiC through the titanizing process were investigated. The titanizing treatment was performed at the ...
CO2-induced mechanical behaviour of Hawkesbury sandstone in the Gosford basin: An experimental study
(Elsevier, 2015)
Carbon dioxide (CO2) sequestered in saline aquifers undergoes a variety of chemically-coupled mechanical effects, which may cause CO2-induced mechanical changes and time-dependent reservoir deformation. This paper investigates ...
Experimental work on mechanical, electromagnetic and microwave shielding effectiveness properties of mortar containing electric arc furnace slag
(Elsevier, 2018)
It is well known that one of the widely used structural materials is ordinary cement mortar. Whereas the mechanical properties are sufficient as structural materials, its shielding effectiveness and prevention properties ...
Microstructural and mechanical properties of friction stir welded pure lead
(National Institute of Science Communication and Information Resources (NISCAIR), 2018)
The present study focuses on the applicability of friction stir welding to pure Pb plates. The joint performances are evaluated by optical microscopy, microhardness measurements, notch impact tests and three point bending ...
Comparative experimental study on the modification of microstructural and mechanical properties of friction stir welded and gas metal arc welded EN AW-6061 O aluminum alloys by post-weld heat treatment
(Wiley-VCH Verlag, 2018)
In this paper, the effects of post-weld heat treatment on modification of microstructures and mechanical properties of friction stir welded and gas metal arc welded AA6061-O plates were compared with each other. Gas metal ...
Optimum design of alkali activated slag concretes for the low oxygen/chloride ion permeability and thermal conductivity
(Elsevier, 2016)
In this research, individual and interactional effect of curing temperature (CT), curing time (Crime), sodium concentration (SC) and silicate modulus (SM) on the compressive strength, chloride ion permeability, oxygen ...
Microstructure and mechanical properties of friction-stir welded St52 steel joints
(Springer, 2018)
The aim of this work is to investigate the mechanical properties and microstructures of friction-stir welded (FSWed) St52 structural steel joints. In this study, St52 steel plates with a thickness of 4 mm were butt-welded ...
Effect of borotitanizing on microstructure and wear behavior of Inconel 625
(Elsevier, 2017)
Inconel 625, a nickel-based superalloy, is used in a wide range of applications including the marine and petroleum industries under where it is subjected to harsh conditions such as high temperatures and highly corrosive ...
Mechanical properties of friction stir welded St 37 and St 44 steel joints
(Carl Hanser Verlag, 2018)
In this study, the weldability of lower strength St 37 grade steel plate with a higher strength steel plate (i. e., St 44) using the friction stir welding technique has been studied. St 37 grade steel sheets are widely ...