Konu "Fluids" için Fakülteler listeleme
Toplam kayıt 8, listelenen: 1-8
-
Comparison of toluene and cyclohexane as a working fluid of an organic Rankine cycle used for reheat furnace waste heat recovery
(Inderscience Publishers, 2016)An organic Rankine cycle (ORC) is set up to recover waste heat from the flue gas of a reheat furnace. The calculations show that, under the same conditions, the gross power production, energy and exergy efficiencies are ... -
An Innovative Experimental Study on Improving the Rheological Properties of Na-Bentonite Water Based Drilling Muds using Graphene, Graphene Oxide and Graphene Oxide Functionalized with Gold Nanoparticles
(Institute of Physics, 2022)In this study; it is aimed to improve the rheological properties of Na-Bentonite water based drilling muds (WBDM) by graphene, graphene oxide (GO) and graphene oxide functionalized with gold nanoparticles (AuNPs/GO) at ... -
Investigation and prediction of viscosity of spud type drilling muds added barite, calcium carbonate and olivine by artificial neural networks with limiting data
(Parlar Scientific Publications, 2021)Drilling is one of the most common methods for the production of hydrocarbon or geothermal sources. Success of drilling operations depend on the mechanical and thermal properties of drilling mud. Since ensure direct connect ... -
Novel decision-making strategy for working fluid selection in Organic Rankine Cycle: A case study for waste heat recovery of a marine diesel engine
(Elsevier, 2022)The Organic Rankine Cycle (ORC) is receiving increasing attention as a waste heat recovery system. However, it is still a major challenge to quickly and practically choose the appropriate one among dozens of working fluids, ... -
Novel Research on CuONPs/MWCNTs Effect on the Properties of Na-Bentonite Water Based Drilling Muds with Experimental Study
(IOP Publishing, 2020)This novel research, aimed to improve the properties of Na-bentonite water based drilling mud (WBDM) and reduce its cost by adding multi-walled carbon nanotubes functionalized with copper oxide nanoparticles (CuONPs/MWCNTs). ... -
Parametric Optimisation of an ORC in a Wood Chipboard Production Facility to Recover Waste Heat Produced from the Drying and Steam Production Process
(Mdpi, 2019)The wastes in wood industries (waste chips) are commonly used as fuel for burners to produce steam and to use the remaining heat in the drying process. However, in spite of that, there is a considerable amount of heat ... -
Parametric optimization and exergetic analysis comparison of subcritical and supercritical organic Rankine cycle (ORC) for biogas fuelled combined heat and power (CHP) engine exhaust gas waste heat
(Elsevier, 2016)In this paper, a subcritical and supercritical organic Rankine cycle (ORC) are designed to recover exhaust gas waste heat of biogas fuelled combined heat and power (CHP) engine. The CHP engine is located in Belgium and ... -
Performance and environmental improvements of a geothermal power plant by using structural and operational modification techniques
(Institution of Chemical Engineers, 2023)Performance data from a geothermal power plant that uses a dry-type working fluid (n-Pentane) was evaluated. The experimental working conditions of the geothermal power plant were recorded. By using these recorded data the ...