Ara
Toplam kayıt 7, listelenen: 1-7
High temperature wear behavior of the surface-modified externally cooled rolls
(Elsevier, 2018)
Externally cooled rolls of a steel plant were coated using three different surface modification techniques, namely titanizing, boronizing and borotitanizing. The grown coatings were examined using optical microscopy, ...
Recent developments in joining of aluminum alloys
(Springer, 2017)
The mass saving potential of light-weight materials, such as Al alloys, is beneficial for fuel economy and reducing CO2 emissions. However, the wide-spread use of these alloys has been long hindered due to the difficulty ...
Wear Behavior of Borided AISI D2 Steel under Linear Reciprocating Sliding Conditions
(Pleiades Publishing, 2019)
AISI D2 steel is the most commonly used cold-work tool steel in its grade. In this study, microstructural characterization and some mechanical properties of borided AISI D2 steel samples were investigated. The boriding ...
Microstructural and mechanical properties of friction stir welded pure lead
(National Institute of Science Communication and Information Resources (NISCAIR), 2018)
The present study focuses on the applicability of friction stir welding to pure Pb plates. The joint performances are evaluated by optical microscopy, microhardness measurements, notch impact tests and three point bending ...
Microstructural and Mechanical Properties of Friction Stir Welded Nickel-Aluminum Bronze (NAB) Alloy
(Springer, 2016)
In this study, the applicability of friction stir welding to cast NAB alloy (i.e., C95800) with a thickness of 9 mm has been investigated. The joint performance was determined by conducting optical microscopy, microhardness ...
A new approach to improve some properties of wire arc additively manufactured stainless steel components: Simultaneous homogenization and boriding
(Elsevier, 2023)
Arc-directed energy deposition (Arc-DED), also commonly referred to as wire arc additive manufacturing (WAAM), is a cost-effective 3D metal additive manufacturing process in which large metallic parts can be produced due ...
Investigation of the wear behavior of FeNi36 alloy cut by WEDM method under different loads
(Emerald Publishing, 2023)
PurposeFeNi36 (Invar-36) alloy is widely used in the fabrication of molding tools in aerospace industries but there remains a need to improve its wear and friction performance due to its relatively low hardness. The formation ...