Ara
Toplam kayıt 156, listelenen: 91-100
Effect of thermal degradation on the properties and wear behavior of Cr−V−C composite coatings grown on ductile iron
(Elsevier, 2021)
The thermal fatigue behavior of chromium vanadium carbide (Cr - V - C) coatings and the wear of the coatings after thermal fatigue cycling was studied. The Cr - V - C coatings were grown on the surface of a ductile iron ...
Low Velocity Impact and Tensile Performance of GFRPs Interleaved with Electrospun Nylon 6,6 Nanofiber Mats
(Strojarski Facultet, 2021)
Nanofibers can be interleaved into polymers and improvements in mechanical properties such as resistance to impact, delamination and debonding as well as enhanced ductility can be obtained. In this work, GFRP laminated ...
Effects of blast furnace slag (BFS) and cobalt-boron (Co-B) on hydrogen production from sodium boron hydride
(Elsevier, 2021)
In the present paper, the blast furnace slag (BFS) supported Co-B catalyst were investigated in detail. The impregnation-chemical reduction method was used while hydrochloric (HCl) acid treated BFS samples (BFS+) were ...
Sensitivity analysis of laminated composite plates with different orientations in low to high order modes
(IOP Publishing, 2021)
Laminated composite plates are utilized due to their high strength/weight ratios. Since such structures are light and have less stiffness, their natural frequencies are lower than usual isotropic structures. Therefore, ...
The effect of nanoparticle additive on surface milling in glass fiber reinforced composite structures
(SAGE Publications, 2021)
In this study, the effect of adding nanosize additive to glass fiber reinforced composite plates on mechanical properties and surface milling was investigated. In the light of the investigations, with the addition of MWCNTs ...
Optimisation of simple and regenerative organic Rankine cycles using jacket water of an internal combustion engine fuelled with biogas produced from agricultural waste
(Elsevier, 2021)
Internal combustion engines have a very important place in biogas production facilities to convert biogas energy to electricity. Unfortunately, although intense studies on improving internal combustion engine efficiencies ...
Microstructure, some mechanical properties and tribocorrosion wear behavior of boronized Al0.07Co1.26Cr1.80Fe1.42Mn1.35Ni1.10 high entropy alloy
(Elsevier, 2021)
High-entropy alloys (HEAs) with face-centered cubic (FCC) structures exhibit high toughness and corrosion resistance, but their average strengths and relatively low wear resistance can limit their engineering ap-plications. ...
An investigation on cutting of the MWCNTs doped composite plates by CO2 laser beam
(Emerald Group Publishing Ltd., 2022)
Purpose The purpose of this study is to obtain strong materials with multiwall carbon nanotubes (MWCNTs) doped and investigate laser cut of MWCNTs also find the effect of the laser cutting parameters on composite materials. ...
A comprehensive comparative energy and exergy analysis in solar based hydrogen production systems
(Elsevier, 2021)
In the presented paper, energy and exergy analysis is performed for thermochemical hydrogen (H2) production facility based on solar power. Thermal power used in thermochemical cycles and electricity production is obtained ...
Analysis of a Kalina cycle integrated with a reheat furnace
(Inderscience Publishers, 2022)
In the present paper, parametric optimisation, energy and exergy analyses of KC were performed together with economic and environmental analyses. After parametric, energy and exergy analyses of KC, maximum net power ...