Ara
Toplam kayıt 20, listelenen: 11-20
Investigation of methanol contaminated local spirit using metamaterial based transmission line sensor
(Elsevier, 2021)
A metamaterial-based transmission line sensor was designed to determine the amount of methanol in methanol-contaminated local spirit samples both numerically and experimentally. The proposed sensor consists of a square ...
Fuzzy logic-based decision support system for selection of optimum input shaping techniques in point-to-point motion systems
(SAGE Publications, 2021)
In this study, a novel fuzzy logic-based decision support system approach to provide assistance in the selection of suitable input shaping techniques is presented. The proposed approach selects the suitable input shaping ...
Effect of thermal degradation on the properties and wear behavior of Cr−V−C composite coatings grown on ductile iron
(Elsevier, 2021)
The thermal fatigue behavior of chromium vanadium carbide (Cr - V - C) coatings and the wear of the coatings after thermal fatigue cycling was studied. The Cr - V - C coatings were grown on the surface of a ductile iron ...
Effects of blast furnace slag (BFS) and cobalt-boron (Co-B) on hydrogen production from sodium boron hydride
(Elsevier, 2021)
In the present paper, the blast furnace slag (BFS) supported Co-B catalyst were investigated in detail. The impregnation-chemical reduction method was used while hydrochloric (HCl) acid treated BFS samples (BFS+) were ...
Sensitivity analysis of laminated composite plates with different orientations in low to high order modes
(IOP Publishing, 2021)
Laminated composite plates are utilized due to their high strength/weight ratios. Since such structures are light and have less stiffness, their natural frequencies are lower than usual isotropic structures. Therefore, ...
The effect of nanoparticle additive on surface milling in glass fiber reinforced composite structures
(SAGE Publications, 2021)
In this study, the effect of adding nanosize additive to glass fiber reinforced composite plates on mechanical properties and surface milling was investigated. In the light of the investigations, with the addition of MWCNTs ...
Optimisation of simple and regenerative organic Rankine cycles using jacket water of an internal combustion engine fuelled with biogas produced from agricultural waste
(Elsevier, 2021)
Internal combustion engines have a very important place in biogas production facilities to convert biogas energy to electricity. Unfortunately, although intense studies on improving internal combustion engine efficiencies ...
Microstructure, some mechanical properties and tribocorrosion wear behavior of boronized Al0.07Co1.26Cr1.80Fe1.42Mn1.35Ni1.10 high entropy alloy
(Elsevier, 2021)
High-entropy alloys (HEAs) with face-centered cubic (FCC) structures exhibit high toughness and corrosion resistance, but their average strengths and relatively low wear resistance can limit their engineering ap-plications. ...
A comprehensive comparative energy and exergy analysis in solar based hydrogen production systems
(Elsevier, 2021)
In the presented paper, energy and exergy analysis is performed for thermochemical hydrogen (H2) production facility based on solar power. Thermal power used in thermochemical cycles and electricity production is obtained ...
The effect of hexagonal nano boron nitride on mechanical performances and machinability behaviors of basalt fabric reinforced epoxy composites
(SAGE Publications, 2021)
The aim of this work is to investigate the effect of the hexagonal nano boron nitride (h-BN) doped epoxy on the mechanical performances and machinability behaviors of basalt fiber (BF) composites. The h-BN has used as a ...