Ara
Toplam kayıt 103, listelenen: 41-50
Quantized control settings based tuning of a heaving wave energy converter in irregular seas
(Taylor and Francis Inc., 2016)
The increasing awareness of environmental issues attracts more attention on environmentally friendly energy sources. This leads to increasing research on effective use of renewable energy sources. Among them, wave energy ...
Mechanical properties of friction stir welded St 37 and St 44 steel joints
(Carl Hanser Verlag, 2018)
In this study, the weldability of lower strength St 37 grade steel plate with a higher strength steel plate (i. e., St 44) using the friction stir welding technique has been studied. St 37 grade steel sheets are widely ...
Microstructural and Mechanical Properties of Friction Stir Welded Nickel-Aluminum Bronze (NAB) Alloy
(Springer, 2016)
In this study, the applicability of friction stir welding to cast NAB alloy (i.e., C95800) with a thickness of 9 mm has been investigated. The joint performance was determined by conducting optical microscopy, microhardness ...
Artificial Intelligence Applications for Friction Stir Welding: A Review
(Korean Institute of Metals and Materials, 2020)
Advances in artificial intelligence (AI) techniques that can be used for different purposes have enabled it to be used in many different industrial applications. These are mainly used for modeling, identification, optimization, ...
Sıcak Presleme Yöntemi ile Üretilmiş Uçucu Kül Takviyeli Bronz Matrisli Fren Balata Malzemelerinin Sürtünme-Aşınma Özellikleri Üzerine Kolemanit Miktarının Etkisi
(Gazi Üniversitesi, 2016)
Bu çalışmada sıcak presleme yöntemi ile üretilen kütlece % 6 uçucu kül takviyeli bronz matrisli fren balata malzemesinin tribolojik özellikleri üzerine farklı oranlarda (% 0,5-4) ilave edilen kolemanit miktarının etkisi ...
An Investigation on Cutting of the MWCNTs-Doped Composite Plates by AWJ
(Springer Heidelberg, 2020)
In this study, cutting of multi-walled carbon nanotubes (MWCNTs)-doped composite sheets by abrasive water jet machining (AWJM) and the effects of the water jet on cut composite materials were analyzed. The influence of ...
HHO enrichment of bio-diesohol fuel blends in a single cylinder diesel engine
(Elsevier Ltd, 2019)
One of the primary aims of this experimental investigation is to examine hydroxy-gas enrichment effects on environmentally friendly but performance-reducing alternative fuels such as ethanol and biodiesel. Hydroxy gas is ...
Performance & emission analysis of HHO enriched dual-fuelled diesel engine with artificial neural network prediction approaches
(Elsevier, 2020)
Most of the studies on conventional fuel types that can be used in internal combustion engines have been made in order to improve performance values. Nowadays environmental problems have shown that emission values are more ...
Fatigue analysis of bolted flange joints of a rotary dryer
(Elsevier, 2016)
This paper describes the fatigue failure of a rotary dryer in a chemical plant. The process conditions required the dryer to be rotated continuously at a speed of about two and half revolutions per minute. The shell structure ...
MWCNTs doped GFRPs drilling: crosscheck among holes obtained by alternative manufacturing methods
(Springer, 2021)
In this study, the holes of glass fiber reinforced polymer (GFRP) and multi-walled carbon nanotubes (MWCNTs) doped GFRP composite materials were drilled using abrasive water jet (AWJ), CO2 laser cutting, orbital drilling, ...