Ara
Toplam kayıt 18, listelenen: 1-10
Investigation of electromagnetic properties of glass-fiber reinforced epoxy composites containing pan nanofibers with mwcnt/graphene additive
(Parlar Scientific Publications (P S P), 2019)
In this work; the differences between of electromagnetic properties of glass fiber reinforced (GFR)-epoxy laminate composites with various nanoparticle doped polyacrylonitrile (PAN) fibers were investigated. The laminated ...
Production of Multi-Walled Carbon Nanotube and Graphene Doped Thermoplastic Polyurethane Fiber and Investigation of Mechanical Properties
(IOP Publishing, 2020)
Nowadays nanofibers are used in many areas. Nanofibers produced by electrospinning are required to be porous, large surface area, lightweight and cost effective. In addition to being lightweight, nanofibers must also have ...
Wear Behavior of Borided AISI D2 Steel under Linear Reciprocating Sliding Conditions
(Pleiades Publishing, 2019)
AISI D2 steel is the most commonly used cold-work tool steel in its grade. In this study, microstructural characterization and some mechanical properties of borided AISI D2 steel samples were investigated. The boriding ...
Electromagnetic Scattering Properties of MWCNTs/Graphene Doped Epoxy Layered with PVC Nanofiber/E-Glass Composites
(Springer, 2020)
In this study, composites composed of glass fiber reinforced-epoxy laminates interleaved with electrospun polyvinylchloride (PVC) nano-fibres were designed for radar absorption investigations. The laminated composites which ...
The effects of interface and matrix reinforcements on fracture toughness of E-Glass/epoxy laminate
(Institute of Physics Publishing, 2020)
In this study, the effects of low amount (0.1 wt%) multi-walled carbon nanotube (MWCNTs) distributed homogenously in epoxy via cationic surfactant (cetyl pyridiniumchloride-CPC), polyacrylonitrile nanofiber (in the range ...
An Investigation on Cutting of the MWCNTs-Doped Composite Plates by AWJ
(Springer Heidelberg, 2020)
In this study, cutting of multi-walled carbon nanotubes (MWCNTs)-doped composite sheets by abrasive water jet machining (AWJM) and the effects of the water jet on cut composite materials were analyzed. The influence of ...
Fatigue analysis of bolted flange joints of a rotary dryer
(Elsevier, 2016)
This paper describes the fatigue failure of a rotary dryer in a chemical plant. The process conditions required the dryer to be rotated continuously at a speed of about two and half revolutions per minute. The shell structure ...
MWCNTs doped GFRPs drilling: crosscheck among holes obtained by alternative manufacturing methods
(Springer, 2021)
In this study, the holes of glass fiber reinforced polymer (GFRP) and multi-walled carbon nanotubes (MWCNTs) doped GFRP composite materials were drilled using abrasive water jet (AWJ), CO2 laser cutting, orbital drilling, ...
An Investigation of Punching the MWCNTs Doped Composite Plates by Using Different Cutting Profiles
(University of Osijek, 2021)
In this study, glass fiber reinforced composite layers which are with and without additives of 0.1 wt.% multi walled carbon nanotubes (MWCNTs) of epoxy were manufactured by vacuum infusion method. Unlike the conventional ...
Investigation of cotton fabric composites as a natural radar-absorbing material
(Emerald Group Publishing Ltd., 2020)
Purpose The purpose of this paper is to investigate cotton fabric behavior that is exposed to radar waves between selected operation frequencies as an alternative radar-absorbing material (RAM) response. Cotton fabric ...