Ara
Toplam kayıt 11, listelenen: 1-10
Investigation of microstructure and mechanical properties of friction stir welded dissimilar St37/St52 joints
(Institute of Physics Publishing, 2019)
Although friction stir welding (FSW) has widely been applied to aluminum alloys in several industries over the past three decades, it is not yet used in industry for joining of steels. The aim of this study is to characterize ...
High temperature wear behavior of the surface-modified externally cooled rolls
(Elsevier, 2018)
Externally cooled rolls of a steel plant were coated using three different surface modification techniques, namely titanizing, boronizing and borotitanizing. The grown coatings were examined using optical microscopy, ...
Recent developments in joining of aluminum alloys
(Springer, 2017)
The mass saving potential of light-weight materials, such as Al alloys, is beneficial for fuel economy and reducing CO2 emissions. However, the wide-spread use of these alloys has been long hindered due to the difficulty ...
Wear Behavior of Borided AISI D2 Steel under Linear Reciprocating Sliding Conditions
(Pleiades Publishing, 2019)
AISI D2 steel is the most commonly used cold-work tool steel in its grade. In this study, microstructural characterization and some mechanical properties of borided AISI D2 steel samples were investigated. The boriding ...
Microstructure and mechanical properties of friction-stir welded St52 steel joints
(Springer, 2018)
The aim of this work is to investigate the mechanical properties and microstructures of friction-stir welded (FSWed) St52 structural steel joints. In this study, St52 steel plates with a thickness of 4 mm were butt-welded ...
Mechanical properties of friction stir welded St 37 and St 44 steel joints
(Carl Hanser Verlag, 2018)
In this study, the weldability of lower strength St 37 grade steel plate with a higher strength steel plate (i. e., St 44) using the friction stir welding technique has been studied. St 37 grade steel sheets are widely ...
Microstructure, some mechanical properties and tribocorrosion wear behavior of boronized Al0.07Co1.26Cr1.80Fe1.42Mn1.35Ni1.10 high entropy alloy
(Elsevier, 2021)
High-entropy alloys (HEAs) with face-centered cubic (FCC) structures exhibit high toughness and corrosion resistance, but their average strengths and relatively low wear resistance can limit their engineering ap-plications. ...
Effect of the boriding environment on the wear response of laser-clad AlCoCrFeNi high entropy alloy coatings
(Elsevier, 2022)
Laser-clad AlCrFeCoNi high entropy alloy (HEA) coatings, produced on the surface of AISI 316 L stainless steel, were pack-borided at 1000 °C for 4 h in open air, high-purity Ar and vacuum environments. The HEA, which had ...
Characterization of electrodeposited Ni-Cr/hBN composite coatings
(Elsevier, 2020)
In this study, NieCr/hBN composite coatings with different hBN content were deposited on AISI 1040mild carbon steel using electrodeposition. The coatings were characterized using scanning electronmicroscopy (SEM), energy ...
A new approach to improve some properties of wire arc additively manufactured stainless steel components: Simultaneous homogenization and boriding
(Elsevier, 2023)
Arc-directed energy deposition (Arc-DED), also commonly referred to as wire arc additive manufacturing (WAAM), is a cost-effective 3D metal additive manufacturing process in which large metallic parts can be produced due ...