Ara
Toplam kayıt 13, listelenen: 1-10
Investigation of microstructure and mechanical properties of friction stir welded dissimilar St37/St52 joints
(Institute of Physics Publishing, 2019)
Although friction stir welding (FSW) has widely been applied to aluminum alloys in several industries over the past three decades, it is not yet used in industry for joining of steels. The aim of this study is to characterize ...
High temperature wear behavior of the surface-modified externally cooled rolls
(Elsevier, 2018)
Externally cooled rolls of a steel plant were coated using three different surface modification techniques, namely titanizing, boronizing and borotitanizing. The grown coatings were examined using optical microscopy, ...
Recent developments in joining of aluminum alloys
(Springer, 2017)
The mass saving potential of light-weight materials, such as Al alloys, is beneficial for fuel economy and reducing CO2 emissions. However, the wide-spread use of these alloys has been long hindered due to the difficulty ...
Wear Behavior of Borided AISI D2 Steel under Linear Reciprocating Sliding Conditions
(Pleiades Publishing, 2019)
AISI D2 steel is the most commonly used cold-work tool steel in its grade. In this study, microstructural characterization and some mechanical properties of borided AISI D2 steel samples were investigated. The boriding ...
Microstructure and mechanical properties of friction-stir welded St52 steel joints
(Springer, 2018)
The aim of this work is to investigate the mechanical properties and microstructures of friction-stir welded (FSWed) St52 structural steel joints. In this study, St52 steel plates with a thickness of 4 mm were butt-welded ...
Mechanical properties of friction stir welded St 37 and St 44 steel joints
(Carl Hanser Verlag, 2018)
In this study, the weldability of lower strength St 37 grade steel plate with a higher strength steel plate (i. e., St 44) using the friction stir welding technique has been studied. St 37 grade steel sheets are widely ...
Friction stir welding/processing of metals and alloys: A comprehensive review on microstructural evolution
(Elsevier, 2021)
The unique combination of very large strains, high temperatures and high strain rates inherent to friction stir welding (FSW) and friction stir processing (FSP) and their dependency on the processing parameters provides ...
Microstructure, some mechanical properties and tribocorrosion wear behavior of boronized Al0.07Co1.26Cr1.80Fe1.42Mn1.35Ni1.10 high entropy alloy
(Elsevier, 2021)
High-entropy alloys (HEAs) with face-centered cubic (FCC) structures exhibit high toughness and corrosion resistance, but their average strengths and relatively low wear resistance can limit their engineering ap-plications. ...
Cu/Al levhaların sürtünme karıştırma kaynağında Taguchi metodu ile çekme mukavemeti ve sertlik için optimum kaynak parametrelerinin tahmini
(Gazi Üniversitesi Mühendislik Mimarlık Fakültesi Dergisi, 2019)
In this study, the effect of welding parameters on the performance characteristic in the friction stir welding of Cu/Al plates were experimentally investigated. Experiments were designed according to Taguchi L9 orthogonal ...
Effect of the boriding environment on the wear response of laser-clad AlCoCrFeNi high entropy alloy coatings
(Elsevier, 2022)
Laser-clad AlCrFeCoNi high entropy alloy (HEA) coatings, produced on the surface of AISI 316 L stainless steel, were pack-borided at 1000 °C for 4 h in open air, high-purity Ar and vacuum environments. The HEA, which had ...