Ara
Toplam kayıt 10, listelenen: 1-10
Exergetic Simulation and Performance Analysis of the Effect of Flow Patterns in PEMFCs
(Int Center Applied Thermodynamics, 2019)
In this study, 6 different novel flow channels of the "proton exchange membrane" (PEM) type fuel cells were designed and modeled, while evaluations were conducted on three-dimensional channels of various designs using ...
Parametric Optimisation of an ORC in a Wood Chipboard Production Facility to Recover Waste Heat Produced from the Drying and Steam Production Process
(Mdpi, 2019)
The wastes in wood industries (waste chips) are commonly used as fuel for burners to produce steam and to use the remaining heat in the drying process. However, in spite of that, there is a considerable amount of heat ...
Determination of Barreling of Aluminum Solid Cylinders During Cold Upsetting Using Genetic Algorithm
(UNIV FED RIO DE JANEIRO, LAB HIDROGENIO, 2019)
This study presents Genetic Programming models for the formulation of barreling of aluminum solid cylinders during cold upsetting based on experimental results. The maximum and minimum radii of the barreled cylinders having ...
Exergy analysis and performance improvement of a subcritical/supercritical organic Rankine cycle (ORC) for exhaust gas waste heat recovery in a biogas fuelled combined heat and power (CHP) engine through the use of regeneration
(MDPI, 2019)
In the present study, a subcritical and supercritical regenerative organic Rankine cycle (rORC) was designed. The designed rORCs assist a combined heat and power (CHP) engine, the fuel of which is biogas produced from ...
Determination of heat transfer coefficient and electromagnetic directional analysis of pomegranate seed
(International Advanced Researches and Engineering Journal, 2019)
As Turkey uses about 25.7% of energy consumption in residential area and doing this with natural gas imported from the abroad, production of efficient insolation materials is important to decrease energy dependence and ...
A review study on ladle slag detection technologies in continuous casting process
(International Advanced Researches and Engineering Journal, 2019)
In steel production, continuous casting method using BOF or EAF is increasing day by day. However, the complex nature of the continuous casting process poses many challenges for steelmakers. During the general steel ...
Experimental investigation of thermal coefficient of the graphene used concrete
(International Advanced Researches and Engineering Journal, 2019)
Today, fossil fuels are used primarily in energy production throughout the world. However, the ever-diminishing energy production and developing technology has encouraged energy recovery, saving or different topics. Grafen ...
A Modeling Study on Surface Roughness of Spinneret Mold Sections Machined By WEDM
(Sakarya University Journal of Science, 2019)
The Wire Electrical Discharge Machining (Wire EDM) is widely used in the cutting of Bulk Continuous Filament (BCF) spinneret molds. Because of the low surface roughness of the spinneret molds obtained by the Wire EDM method, ...
A Study On Prediction of Surface Roughness and Cutting Tool Temperature After Turning For S235JR Steel
(Konya Mühendislik Bilimleri Dergisi, 2019)
In machining technologies, the most important criterion taken into consideration whenevaluating the product quality is seen as the surface roughness. In the consideration of productionquality and cost, tool wear is one of ...
Designing, Modeling and Simulation of Solid Fuel Rocket ALP-01
(Avrupa Bilim ve Teknoloji Dergisi, 2019)
In this study the design of solid-fuel low-altitude rocket ALP-01 CAD has been optimized for the selected engine of rocket sizes foran altitude of 1500 meters. Parabolic type was preferred as the cone geometry. The length ...