Ara
Toplam kayıt 6, listelenen: 1-6
Exergetic Simulation and Performance Analysis of the Effect of Flow Patterns in PEMFCs
(Int Center Applied Thermodynamics, 2019)
In this study, 6 different novel flow channels of the "proton exchange membrane" (PEM) type fuel cells were designed and modeled, while evaluations were conducted on three-dimensional channels of various designs using ...
Parametric Optimisation of an ORC in a Wood Chipboard Production Facility to Recover Waste Heat Produced from the Drying and Steam Production Process
(Mdpi, 2019)
The wastes in wood industries (waste chips) are commonly used as fuel for burners to produce steam and to use the remaining heat in the drying process. However, in spite of that, there is a considerable amount of heat ...
Determination of Barreling of Aluminum Solid Cylinders During Cold Upsetting Using Genetic Algorithm
(UNIV FED RIO DE JANEIRO, LAB HIDROGENIO, 2019)
This study presents Genetic Programming models for the formulation of barreling of aluminum solid cylinders during cold upsetting based on experimental results. The maximum and minimum radii of the barreled cylinders having ...
Exergy analysis and performance improvement of a subcritical/supercritical organic Rankine cycle (ORC) for exhaust gas waste heat recovery in a biogas fuelled combined heat and power (CHP) engine through the use of regeneration
(MDPI, 2019)
In the present study, a subcritical and supercritical regenerative organic Rankine cycle (rORC) was designed. The designed rORCs assist a combined heat and power (CHP) engine, the fuel of which is biogas produced from ...
Bir modal empedans tabanlı istatistiksel enerji analizi yordamı ile çizgisel bağlantılı belirsiz kompozit yapıların orta ve yüksek frekans titreşim analizi
(Gazi Üniversitesi Mühendislik-Mimarlık, 2019)
In this study, mid and high frequency vibration analysis of line connected composite structures having structural uncertainty obtained by mass variability is performed by using a procedure of modal impedance based statistical ...
Cu/Al levhaların sürtünme karıştırma kaynağında Taguchi metodu ile çekme mukavemeti ve sertlik için optimum kaynak parametrelerinin tahmini
(Gazi Üniversitesi Mühendislik Mimarlık Fakültesi Dergisi, 2019)
In this study, the effect of welding parameters on the performance characteristic in the friction stir welding of Cu/Al plates were experimentally investigated. Experiments were designed according to Taguchi L9 orthogonal ...